TRX250r.org

Author Topic: Jetting for ct pipe  (Read 2895 times)

Offline lrd_250r

Jetting for ct pipe
« on: September 14, 2016, 08:55:09 AM »
Boys, I need help with jetting...

1985 atc250r
Stock carb
Airbox with lid
900 ft elevation
CT Racing pipe


Sent from my SM-G900V using Tapatalk

Offline lrd_250r

Jetting for ct pipe
« Reply #1 on: September 14, 2016, 10:27:12 PM »
Sorry also no porting, stock motor

Sent from my SM-G900V using Tapatalk

Offline StrokedAZ

Jetting for ct pipe
« Reply #2 on: September 15, 2016, 10:42:42 AM »
I live about 2000ft and I use stock jetting.  48 pilot and ~150 main, air screw is 1 1/2 out I think.  This jetting worked for the FMF that it came with and the CT national I put on.  My lid is off though and I have a RAD valve which calls for 1 size smaller main.  Hope that helps.  To tell you the truth I would verify what needle you have because that can make a huge difference.

Sent from my Galaxy S5
86 TRX 250R

Offline lrd_250r

Jetting for ct pipe
« Reply #3 on: September 15, 2016, 10:18:41 PM »
Thanks, now I have a starting point

Sent from my SM-G900V using Tapatalk

 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38