Adjusting with spanner wrench whats a good setting for rear shock

[DeathPunch88_250R]

Need some info on how to set the spring load on the rear shock. My weight is 185lbs

[broken1]

The factory spring preload setting for the 88 shock is 8.66"-8.86".

[DeathPunch88_250R]

Cool Deal Thanks Kevin

[Burns363R]

I would set it for your ride height.  Depending on your riding. around 7.5-8" at the rear peg tube to the ground.  If your less than that, stiffen it, if your more than that soften it.

[DeathPunch88_250R]

Cool Deal Thanks guys.

[2ndmoto]

Look up "setting sag". It is rider weight dependent. Numbers given are a good starting point but generic. However it is all rider preference.

[fearlessfred]

With you fully geared up you should use 1/3 of your travel on a oem setup ,a little over 3 inches of sag from full extension .If you have to preload the crap out of the spring ,you need a heavier spring. The correct spring will need only to be snugged down to hold you up to the correct height .

[jcs003]

fearlessfred is a suspension guru.  follow his advice.

john