do yall have a picture of one of these silencers? im just curious what they look like.
They are 4 1/2" in diameter and 14" long. I made my own core as Cascade cut perf tube that left raw ends. Eventually these raw ends break apart and your core falls to the bottom of the silencer. I spent much time building these cores as the holes are not in a straight line. This helps with sound absorption.
Looking down the inside you can see the front end-cap. It starts out 3/4" thick and is turned on the lathe to leave a 1/2 spout that the core rests in. They came with 2 mounting holes for the stinger, I added 4 more.
The rear end-cap has been turned down to fit precisely the 4 1/2" canister. It has a turn down pressed in and o-ring cut in for sealing. Has 3 equally spaced threaded mounting holes. The canister has clearance holes for the threaded end cap. It uses three 5mm screws to hold it in.
The font end-cap has a 1 1/4" hole with a o-ring cut for the seal. The 1 1/4 hole is used as a through hole for the big bore pipe. Big bore stingers are 1 1/8' ID 1 1/4" OD
I will post the stinger set up next