Author Topic: Grommets? (Read 2591 times)

shawnhart87r · « **on:** August 09, 2020, 01:42:35 PM »

I'm restoring my 87r and found home-made electrical tape grommets on the 2 pegs for the air box. Does anyone know where I can find two of these or if theres a company that makes aftermarket? They are part #28 on babbitsonline. Also looking for a good connecting tube from airbox to carb. Any help appreciated!

The norm · « **Reply #1 on:** August 09, 2020, 02:20:32 PM »

I just ordered as set I found on Ebay. Other than that you could go to an Ace Hardware store or something similar and see what you can find.

desertR · « **Reply #2 on:** August 09, 2020, 04:02:29 PM »

I ordered a few from Babbit's, but it has been a few years ago. I have 1 or 2 for spares as I figured these would become NLA by the next time I needed some. I've seen then on Ebay also, no idea on quality, but they are a lot more expensive then OEM. Guess I better look for those, and put them somewhere I will remember.
desertR

broken1 · « **Reply #3 on:** August 09, 2020, 04:39:32 PM »

If your not going for a 100 point restoration you could use two of the front fender mounting grommets & modify them to work as the airbox grommets. I just measured both & there the exact same diameter & only .025" difference in height(fender grommets are slightly taller). The fender grommets are also still available from Honda for under $5 each, just have to cut the flanges down. 1st pic is a fender grommet on left & airbox grommet on right.

Action69 · « **Reply #4 on:** August 09, 2020, 04:49:02 PM »

There is a guy on eBay but theyre $30 for the pair

croat1 · « **Reply #5 on:** August 09, 2020, 05:41:36 PM »

Quote from: broken1 on August 09, 2020, 04:39:32 PM

If your not going for a 100 point restoration you could use two of the front fender mounting grommets & modify them to work as the airbox grommets. I just measured both & there the exact same diameter & only .025" difference in height(fender grommets are slightly taller). The fender grommets are also still available from Honda for under $5 each, just have to cut the flanges down. 1st pic is a fender grommet on left & airbox grommet on right.

[/quot
Quote from: broken1 on August 09, 2020, 04:39:32 PM
If your not going for a 100 point restoration you could use two of the front fender mounting grommets & modify them to work as the airbox grommets. I just measured both & there the exact same diameter & only .025" difference in height(fender grommets are slightly taller). The fender grommets are also still available from Honda for under $5 each, just have to cut the flanges down. 1st pic is a fender grommet on left & airbox grommet on right.

Just like Kevin stated or find used ones.

Joe

desertR · « **Reply #6 on:** August 09, 2020, 10:01:16 PM »

I guess I should order a few more from Babbits, while they are still available

start a new list ?

desertR

Vegas_Trx250r · « **Reply #7 on:** August 06, 2023, 11:37:40 AM »

Hey

Not sure if you found them. But if you look at Amazon they have some close to stock look a like.

croat1 · « **Reply #8 on:** August 07, 2023, 08:41:39 AM »

Langbolt found a solution