TRX250R.ORG

FAQ's & Technical Articles => Techincal Section => Topic started by: marine on October 02, 2014, 02:59:19 AM

Title: removing rear sprocket holder
Post by: marine on October 02, 2014, 02:59:19 AM
Hi guys how in the hell do you remove the rear sprocket holder off an axle? And if I manage to get it off and put it back together ho do i know if its lined up with the front sprocket? Thanks guys in advance for your help!..USMC
Title: removing rear sprocket holder
Post by: F-Red on October 02, 2014, 01:00:40 PM
They are press fit. They only way I have removed them, was with a hydraulic press. Push it a little towards the center of the axle, remove the ring-clip. Then press it off the opposite direction. Install in reverse.
With the hub set tight on the ring-clip, chain alignment should be good.


No soldier, left behind!!!!! Free Andrew Tahmooressi USMC !!!!!
Title: removing rear sprocket holder
Post by: marine on October 02, 2014, 01:16:51 PM
Quote from: F-Red;43724
They are press fit. They only way I have removed them, was with a hydraulic press. Push it a little towards the center of the axle, remove the ring-clip. Then press it off the opposite direction. Install in reverse.
With the hub set tight on the ring-clip, chain alignment should be good.


No soldier, left behind!!!!! Free Andrew Tahmooressi USMC !!!!!

Thanks Red for the info...WE LEAVE NO ONE BEHIND THIS MARINE WILL BE COMING HOME SOON ONE WAY OR ANOTHER!!!...SEMPER FI..!!!
Title: removing rear sprocket holder
Post by: Tbone07 on October 02, 2014, 01:30:00 PM
Quote from: marine;43698
how do i know if its lined up with the front sprocket? Thanks guys in advance for your help!..USMC

Like F-Red said........the circlip on the sprocket hub will set the alignment of the sprocket. Then when you snug up the big axle nut, everything will be aligned