TRX250r.org

See likes

See likes given/taken


Your posts liked by others

Pages: [1]
Post info No. of Likes
The Face Matches The Name Me and the kids....

June 08, 2014, 02:01:13 AM
1
Show off you xc quad Full Laeger - narrow XC frame, +3 protrax, cr500 powered by a Pc2000 265 w/cr ignition, duncan pipe, reed, and pj carb bored to 37.3.  Honda plastic and bumper.  RPM XC axle.  Baldwin hubs.  Shamrocks wrapped with Razr2.  Axis front and rear.  Protect belly and swing skid.  Roll pegs.  88 bottom completely rebuilt with hinson basket, billet shift forks, new crank, and LED 2nd gear.



May 06, 2015, 10:19:18 PM
1
Round2six7xc Say hello to my XC bottom.  It’s a Kody Schorr built engine with his full billet tranny.

I’m in no hurry and there’s no timeline but this bad boy will sing someday.




March 18, 2018, 09:26:07 PM
1
Re: Laeger's Pro-Trax Shock Bolt & Nut Pretty sure I use 300ex a-arm bolt Part# 90183-HC0-770. 
I think I grind the flange down just a little.  It’s been a while.

March 18, 2018, 09:46:15 PM
1
Re: Round2six7xc He’s the guy out in Tower City that used to wrench for Tony Kellner behind the scenes back in the Hawk days.  He’s pretty much the go to guy for a R bottom end....or anything r for that matter.  He’s not big on FB or the internet.
March 18, 2018, 10:13:04 PM
1
Re: CR500 Link - School Me on Offsets and Finer Details Here's an ISF and a Laeger - both new.  Basically identical.  Steve runs a little smaller diameter pivot hole so you got to grind the goofy cr500 flange bolt to make it fit.  That’s a bolt that needs a replacement since Honda discontinued.  Sure would be nice if someone could play around with a crf450 linkage.

March 18, 2018, 10:40:50 PM
2
Re: 2015 walsh xc Lol.  I have been on here for a long time.  But I’m back.  I started a brand new build post.  And NO the frame is not ready...but it is getting closer.

March 18, 2018, 11:02:29 PM
2
Re: Round2six7xc walsh or isf whichever comes first.  i'm kinda into the ltr and ktm for the most part so i sold a lot of my r stuff.  i have a decent amount of key parts laying around to be active though...  just waiting on a frame.

March 21, 2018, 11:30:14 PM
1