TRX250R.ORG
»
Workshop
» Engine and Bottom End
View full version:
Engine and Bottom End
«
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
»
stroke vs. deck height esr cases
distorted a piston
Best place to buy gaskets?
Puma build pricing?
ESR Spacer plate
Drive gear sizes
cylinder and piston question
possibly a dumb question (looking for extra bottom end)
bored ESR cases compatibility
Water outlet gaskets for a CPI cyl
sphynx questions.
What is this?
Radiator Recommendations
ESR 330pv water passages?
Top-end gasket kit question
1986 250R Bottom end
Looking at replacing or upgrading my ignition
Overheating! Please Help!
Millenium or LA Sleeve? Time to re-sleeve, thoughts on nikasil
whats everyone running with a pump gas dome?
Cobra Racing
Leaking coolant arond cool head studs
Mugen ported cylinder ?
Thinking About a BB
Carb and reed spacers
How much fuel wash is too much ?
Port timing question
Yukon Cryo Override Tranny vs McCoy Billet?
What happend to my spark??
flywheel key
Shift drum tranny issue?? Nuetral??
running hot
crank gear and cb timing
Polaris 400 Cylinder on 250r
need washer
clutch basket question
damaged cases
trans spacer/washer?
any engine builders have tips on engine assembly??
Main shaft gear question HELP!!
silicone on gaskets
Finding a Pro X piston kit
Milky oil from the counterbalancer?
i didnt know
Water pump outlets
msd
sphynx gearing?
+4 mm Crank question
Pilot top end
Aftermarket Gears - Need Info on Teeth & Ratios for Yukon HD's & Baldwins