TRX250r.org

See likes

See likes given/taken


Posts you liked

Pages: [1] 2 3 ... 22
Post info No. of Likes
The Face Matches The Name Me and the kids....

June 08, 2014, 02:01:13 AM
1
center mount air box. air box lid done.
February 22, 2016, 01:46:56 PM
1
lets see your pets
My parents fawn boxer pup and my brindle.

Sent from my SAMSUNG-SM-G890A using Tapatalk

December 11, 2016, 12:42:05 AM
1
lets see your pets
December 11, 2016, 08:19:40 PM
1
Tow Rigs Let's see your guys tow rigs
The new crummy just waiting to put the factory fifth wheel rails in it.

Sent from my SAMSUNG-SM-G890A using Tapatalk

December 31, 2016, 04:42:18 PM
1
Tow Rigs 2012 Cummings


December 31, 2016, 06:10:28 PM
1
Re: New guy and my new R
Nice quad! I was going to suggest you could salvage that frame with a gusset kit & repair cracks. But that missing section though

Thanks! Yea it's a bummer for sure. It could maybe be patched up, but not sure it's even worth the time.

some flat stock and a gusset kit and you will be set.

http://www.tlr-online.com/trx250r/gusset_kits

Joe

July 17, 2018, 03:20:29 PM
1
Re: New guy and my new R I have a wrecked frame I could cut that section out of for you. It could be that whole tube.
July 17, 2018, 03:22:02 PM
1
Re: New guy and my new R Welcome.nice machine/Parts list..you should post up a wanted add with your location I’m sure you’ll get some hits.frames are around.ive also had frames shipped from west coast to nyc for under $100 using greyhound..that works if both you guys have access to a depot nearby..
July 17, 2018, 03:23:12 PM
1
Re: New guy and my new R Welcome aboard. I have done a few frame repairs and have found it to not be as hard as I originally thought. The lower frame rails are 22mm, but 7/8" square tube is an almost perfect fit. I would suggest pulling the engine out and buying a gusset kit from pumashine. I cut out both of the lower engine mount tubes and replaced them. Then set a spare set of cases in the frame so I could line up the new mounts. It came out perfect. Enjoy,  Loren
July 17, 2018, 04:28:44 PM
1