TRX250R.ORG
»
Workshop
» Carburetor, Intake, and Exhaust
View full version:
Carburetor, Intake, and Exhaust
«
1
2
3
4
5
6
7
8
40.5 carb for alky
carb sugguestions
Petcock mod flow data
Needle Recommendations
race fuel
Esr 330r jetting
Jetting a new 344
cr 500 link intake boot
cant figure this out
Esr 38 mm as carb
New carb to intake boots now available?
Jetting my 310
cuttler 58 x 68mm on methanol
38 airstryker questions...
Racing fuel questions
Look at my plug chop
methanol setup
Aluminum air box and shrouds
Anybody else running rich down low with dual stage reeds??
mikuni 41.5 esr carb any good?
whats next after break-in jetting?
Loading up at partial throttle
Reed spacer opinions
Billet Carb Air Boot and Intake Straps For ATC/w 38mm AS???
Air intake tube...keep it or lose it?
Leaking gas
lectron carb help
Jetting, a pain in the D!
Hard starting 330
Need a little help
tool less ajusttable Keihin air screw
Burning through spark plugs
lectron carb help
Issue
quick question about my jetting