View full version: Carburetor, Intake, and Exhaust
« 1 2 3 4 5 6 7 8 »
  1. New intake
  2. bigger engine wanting less fuel?
  3. Any idea what pipe this is?
  4. Anyone dyno different size carbs on the same motor?
  5. Smart Carb Feedback
  6. rich at 1/4 throttle
  7. Need Jetting help on a new build
  8. NO-Link Intake
  9. Opinions on my plug chop
  10. Mikuni TMS
  11. Plug chop on 350 Pro-X
  12. Snorkel for big bores
  13. 88 250r running to rich?
  14. Silencer?
  15. High idle still.
  16. Pro-x vs Sphinx jetting
  17. Idle screw? 39mm keihin pwk
  18. Keihin 38 mill pj.
  19. What is a good carb for a moderately built 250R
  20. Jetting suggestions for my 86 R
  21. Oil Properties
  22. another carb and more questions (41.5mm pwk air striker)
  23. ESR TRX 5B Tuning?
  24. taper bored 39mm pwk identification
  25. airbox lid VS outerwear lid
  26. silicone intake tube
  27. Best place to buy carb needle
  28. Replace VForce reeds or switch to RAD valve?
  29. Amsoil Dominator 50/1?
  30. Oil
  31. ESR 5b
  32. Reeds
  33. Looking for Info on LRD Pipe
  34. Jetting and idle advice
  35. VP Racing - C50 & T2 Race Gas with Pre-Mix 40:1
  36. Modifying 5b cm?
  37. FMF turbine core or Pro Curcuit type 296
  38. Anyone running esr cm pipes with led style intake?
  39. Trinity IV pipe
  40. air box lid
  41. 44mm lectron on a 363 sphynx?
  42. TRX250R Center Mount Pipe Questions - ESR TRX11 / TRX5
  43. 48 lectron fitment
  44. Pipe repair
  45. Lrd bb pipe
  46. Smart Carb
  47. Where to get the slide spring for 39mm keihin 39mm carb
  48. need help , crankshop carb for my Puma
  49. Need help with a running issue please..
  50. Help me 250R Forum .... your my only hope (stalling problem).