View full version: Carburetor, Intake, and Exhaust
« 1 2 3 4 5 6 7 8 »
  1. new carb or stay with stock kehin
  2. Trinity Stage IV pipe question
  3. Carb bell extender
  4. Stumped with a jetting issue
  5. New intake
  6. bigger engine wanting less fuel?
  7. Any idea what pipe this is?
  8. Anyone dyno different size carbs on the same motor?
  9. Smart Carb Feedback
  10. rich at 1/4 throttle
  11. Need Jetting help on a new build
  12. NO-Link Intake
  13. Opinions on my plug chop
  14. Mikuni TMS
  15. Plug chop on 350 Pro-X
  16. Snorkel for big bores
  17. 88 250r running to rich?
  18. Silencer?
  19. High idle still.
  20. Pro-x vs Sphinx jetting
  21. Idle screw? 39mm keihin pwk
  22. Keihin 38 mill pj.
  23. What is a good carb for a moderately built 250R
  24. Jetting suggestions for my 86 R
  25. Oil Properties
  26. another carb and more questions (41.5mm pwk air striker)
  27. ESR TRX 5B Tuning?
  28. taper bored 39mm pwk identification
  29. airbox lid VS outerwear lid
  30. silicone intake tube
  31. Best place to buy carb needle
  32. Replace VForce reeds or switch to RAD valve?
  33. Amsoil Dominator 50/1?
  34. Oil
  35. ESR 5b
  36. Reeds
  37. Looking for Info on LRD Pipe
  38. Jetting and idle advice
  39. VP Racing - C50 & T2 Race Gas with Pre-Mix 40:1
  40. Modifying 5b cm?
  41. FMF turbine core or Pro Curcuit type 296
  42. Anyone running esr cm pipes with led style intake?
  43. Trinity IV pipe
  44. air box lid
  45. 44mm lectron on a 363 sphynx?
  46. TRX250R Center Mount Pipe Questions - ESR TRX11 / TRX5
  47. 48 lectron fitment
  48. Pipe repair
  49. Lrd bb pipe
  50. Smart Carb