TRX250R.ORG

Workshop => Engine and Bottom End => Topic started by: Goon250r on August 22, 2013, 06:09:40 PM

Title: Chipped Motor
Post by: Goon250r on August 22, 2013, 06:09:40 PM

[ATTACH=CONFIG]1492[/ATT    can this be fixed or buy new cases

Title: Chipped Motor
Post by: jamieg45 on August 22, 2013, 06:20:12 PM

Do you have the piece that broke off, if so go get it tig welded back on and ground down and smooth and make it look good.

Title: Chipped Motor
Post by: Goon250r on August 22, 2013, 06:22:16 PM

Quote from: jamieg45;9596

Do you have the piece that broke off, if so go get it tig welded back on and ground down and smooth and make it look good.

sure don't  been riding like this for the past 3 years just figured out what's been crackn my frame (s)    think a multipass will work?

Title: Chipped Motor
Post by: jamieg45 on August 22, 2013, 06:44:12 PM

Yah I would just have a experienced welder weld on it, have him build it up and then do some nice grind work with a dremmel or some diamond bits and it wil be like new again.

Title: Chipped Motor
Post by: sameltoe on August 22, 2013, 07:16:19 PM

Gotta have good heat control with the multi-pass.

Title: Chipped Motor
Post by: ytman on August 22, 2013, 08:44:02 PM

Multipass[ATTACH=CONFIG]1496[/ATTACH] Sorry, I couldn't resist

Title: Chipped Motor
Post by: Tbone07 on August 22, 2013, 10:41:04 PM

I'm sure an experienced welder could Tig weld it and fill that hole. Then drill it out and tap it