TRX250R.ORG

Workshop => Carburetor, Intake, and Exhaust => Topic started by: The_Steve_Man on February 03, 2014, 06:55:25 PM

Title: High Idle
Post by: The_Steve_Man on February 03, 2014, 06:55:25 PM

I just replaced my stator and coil and now I can't get it to idle down.
 It ran fine before the stator went out.  I have an 85 motor with a 39mm PWK.  I have the idle screw all the way in and it still idles way high.
Any suggestions?

Title: High Idle
Post by: rk88r on February 03, 2014, 07:05:32 PM

Air leak, cable f'ed where it goes into carb?

Title: High Idle
Post by: rk88r on February 03, 2014, 07:07:16 PM

Stator side seal out and now the cover is off or not sealed up as well as before?

Title: High Idle
Post by: The_Steve_Man on February 14, 2014, 06:41:56 PM

Got it fixed.  
Apparently I had weak spark and when i replaced the stator and coil,  I have good spark.
I couldn't figure why it was fine before the stator went out it ran fine and after it had a high idle. I adjusted the idle screw but not enough.  I had to screw it way out from where it was before.  

Just trying use my experience (or lack of) to help somebody else.

Title: High Idle
Post by: rk88r on February 15, 2014, 12:19:50 AM

Glad you're riding man.

Title: High Idle
Post by: jcs003 on February 15, 2014, 07:23:54 AM

time for a plug chop.

john

Title: High Idle
Post by: The_Steve_Man on February 15, 2014, 09:06:13 AM

Snow is finally gone. Going to be 55 today.  Good day to tune.