TRX250R.ORG

Workshop => Engine and Bottom End => Topic started by: bholzgen on July 08, 2013, 11:22:35 PM

Title: CR Ignition Thread
Post by: bholzgen on July 08, 2013, 11:22:35 PM

I just purchased a CR Ignition.  I am running the pro armor killswitch, and I do not understand how it hooks up to the CR setup.  I have always delt with the stock 250R systems that were less complicated.  If someone could post a pic that would be helpfull.  

Thanks, Blake

Title: CR Ignition Thread
Post by: rsss396 on July 09, 2013, 06:44:36 AM

you will see a pair of wires on the CR harness for the kill circuit, a all black wire and a black wire with a white stripe

connect one wire from the kill switch to the CR harness's black wire
 and the other kill switch wire to the black/white wire of the CR harness.

that should take care of it

Title: CR Ignition Thread
Post by: silverlake250r on July 09, 2013, 08:49:49 AM

Ha, what did I tell you! Connect them both to the kill switch!

Title: CR Ignition Thread
Post by: Rupp250 on July 09, 2013, 10:22:52 AM

How is the CR setup more complicated, there is like 3-4 wires(can't really remember) compared to the stock 20.