So i'm guessing Laeger is unwilling or unable to make these anymore? Or are you able to make them at a lower cost than Laeger?
I'm assuming ikas can make these cheaper. this is a Laeger Protrax component price sheet from maybe 3 years ago (prices might be higher now???):
per Laeger: It is a lot cheaper to purchase a complete spindle ($850) instead of the individual parts, but here you go:
Item Qty Per Spindle Price Total Unit Cost
Aluminum Body 1 $425.00 $425.00
T-Pin 1 $200.00 $200.00
Thrust bearing 1 $51.96 $51.96
Lower Bearing 1 $16.13 $16.13
Bearing Collar 1 $7.53 $7.53
Spindle Shaft 1 $100.00 $100.00
Shaft Collar 1 $27.50 $27.50
Dust Seal 1 $4.18 $4.18
Back Plug 1 $5.25 $5.25
LG Zerk Fitting 1 $1.66 $1.66
Mono Ball Kit (Lower) 1 $35.00 $35.00
Mono Ball Kit (Upper) 1 $35.00 $35.00
Snap Ring 2 $1.25 $2.50
SM Zerk 2 $0.98 $1.96
Set Pin 1 $0.5 0 $0.50
Lug Assembly 1 ? ? not sure what is considered the lug assembly
Lug Body 1 $100.00 $100.00
Brass Bushings 2 $12.00 $24.00
SM Clevis 1 $100.00 $100.00
Lock Nut 1 $1.75 $1.75
SM Zerk 1 $0.50 $0.50
1/4 x 28 Lug Bolt 2 $1.75 $3.50
1/4" Washers 4 $0.50 $2.00
1/4" Lock Nuts 2 $1.25 $2.50
7/16" Bolt 2 $25.00 $50.00
7/16" Nut 2 $1.50 $3.00
5/8" Bolt 2 $2.50 $5.00
5/8" Nut 2 $1.75 $3.50
total per spindle: $1,209.92 if purchased by individual parts