TRX250R.ORG
Workshop => Engine and Bottom End => Topic started by: troybilt on June 10, 2014, 09:21:31 PM
-
I've seen the pilot cylinders on a 250r bottom end, what about a Saber on a Pilot bottom end? Just picked up my second pilot this evening, this one is going to be mine... mostly... hehe....
-
I've also see the rotax kits out there, 540's, 670's, etc... I am considering it, but would rather keep the Honda "guts"...
-
Do a liger..I'd think the bolt pattern would be closer (total guess) and you'll get more displacement. I believe the cr500 and fl400 strokes are both 79mm so the liger would be cast close for the stock stroke.
-
Do a liger..I'd think the bolt pattern would be closer (total guess) and you'll get more displacement. I believe the cr500 and fl400 strokes are both 79mm so the liger would be cast close for the stock stroke.
Ah.. I forgot about the liger... where's rsss when you need him. I've seen several with CR500 cylinders on them, might be onto something there.
-
Might be helpful http://pilotodyssey.com/PO/viewtopic.php?f=1&t=6849
-
I've seen the pilot cylinders on a 250r bottom end, what about a Saber on a Pilot bottom end? Just picked up my second pilot this evening, this one is going to be mine... mostly... hehe....
Troy, the pilot can be bored to 85mm like a Puma. But that is the last bore. If you stroke it to a 4mil crank you will end up with a 431. But it seems you may want to look at a Liger. Good luck with whatever you choose to pursue.
-
I am sure a good amount of welding would still need to be done with a liger, troy send me your email again I lost your contact info with my new phone, I have some files that maybe would help
-
I'll shoot you an email