TRX250R.ORG
General => Lounge => Topic started by: udontknowme on January 20, 2015, 07:59:14 PM
-
does anyone have a radvalve on thier engine they can take a look at the clamps that hold the rubber boot to the carb and see what size they are. seems like their a gemi brand but im wondering what the size is. it should be stamped on the side. something like 48 or 50 maybe.
-
the clamps on mine say 48mm but they arent original just stainless clamps from the parts store.
-
(http://forums.trx250r.org/vbulletin_imports/803_4396_2017-04-18_4716.jpg)
-
wyatt thnx for the info. i was figuring they were somewhere around 48
usmoney are those originals ? reason i ask is because the radvalves that use 38mm carbs use the 54mm gemi clamps. for some reason i thought 250r used a smaller carb like 36mm, there for the clamps would be a bit smaller also im assuming. like around 48 or 50mm ? im needing a gemi clamp in the 48-50mm range. figured maybe i could get a 250r version and it would be the size i needed
-
I had one of the gemini clamps break while riding so I replaced them with these heavier stainless ones from McMaster. I think I used the same size for all 3 and just trimmed the excess off the reed valve clamps.
(http://i97.photobucket.com/albums/l209/mx91a/EEF2B955-CB64-4031-A861-6DB05BE13EAE-21792-00001E5C3E1F21FF_zps42ec4ca2.jpg~original)
-
wyatt thnx for the info. i was figuring they were somewhere around 48
usmoney are those originals ? reason i ask is because the radvalves that use 38mm carbs use the 54mm gemi clamps. for some reason i thought 250r used a smaller carb like 36mm, there for the clamps would be a bit smaller also im assuming. like around 48 or 50mm ? im needing a gemi clamp in the 48-50mm range. figured maybe i could get a 250r version and it would be the size i needed
Bought the rad valve with the boot/clamps used so I can't confirm if their originals...Never gave it much thought sorry!