TRX250R.ORG

Workshop => Engine and Bottom End => Topic started by: twistedwrench on June 20, 2015, 11:08:40 PM

Title: 68mm piston kit for 88250r suggestions
Post by: twistedwrench on June 20, 2015, 11:08:40 PM

I have a jug ported by esr has a 68 mm bore is this a good set up and any part numbers on 88 piston kit for 68mm piston any pros and cons would be appreciated

Title: 68mm piston kit for 88250r suggestions
Post by: rk88r on June 22, 2015, 12:37:09 PM

There should be a stamp on your piston indicating the type and size. I wouldn't alter the setup without the advice from an experienced builder. There are differences in pistons depending on rod length.