TRX250R.ORG

Workshop => Engine and Bottom End => Topic started by: Rupp250 on December 21, 2015, 12:54:15 PM

Title: ESR Cases
Post by: Rupp250 on December 21, 2015, 12:54:15 PM

Going to be buying some here soon. Anyone have the black one? How is the finish holding up. Does it stain with dirt/mud? Will probably buy the complete bearings and seals/gasket kit as well. Is it truly complete?

Title: ESR Cases
Post by: Rupp250 on December 22, 2015, 07:04:42 PM

No one is running a set of theses cases?

Title: ESR Cases
Post by: huntertools on December 22, 2015, 07:33:14 PM

I have a set put together but have not run them yet. Everything went together well and hope to get this motor in soon. Have been using the clutch cover side for some time now and it looks really good after many rides. Clutch cover has the same finish as the cases. I also had Eddie put in bearings and seals and was very pleased with my cases. Hope this helps.
Allen

Title: ESR Cases
Post by: hontrx265r on December 22, 2015, 10:08:30 PM

I had a set of black anodized cases. It seemed to hold up well but I didnt have them all too long. Went to a bigger setup and bought a new set. Happy with the cases though.

Title: ESR Cases
Post by: Quick310r on December 22, 2015, 10:20:42 PM

I have assembled a couple of engines with Esr cases, had absolutely no problems with them,I know several other people that run his cases no problems with them, I do not know anything about the black anodized cases or how they will hold up.