TRX250R.ORG

Member Services => Introductions => Topic started by: TRXDAN on January 01, 2016, 04:40:31 PM

Title: New Member
Post by: TRXDAN on January 01, 2016, 04:40:31 PM

Hey everyone my name is Daniel i am from Albuquerque New Mexico i was turned onto this site by Skeans1. Says theres tons of good folks on here with lots of good info. hope to chat with you guys some.

I have a 89 trx250r with a esr310 paul turner pipe, +6 swing arm lots of chromed parts ect. i picked it up from a guy in glendale az, he didnt know what was done other than pipe and carb. when i took the cylinder off it was a virgin bore and stock piston, you could see the cross hatches but were light. i just installed the used esr310 kit i bought off ebay (complete 86 motor) and bought a spacer plate and ran her..what a gain in power didnt expect that. but anyway looking forward to chat.
                                                                                                                         
(http://forums.trx250r.org/vbulletin_imports/1637_6968_2017-04-18_879.jpg)(http://forums.trx250r.org/vbulletin_imports/1637_6969_2017-04-18_8327.jpg)(http://forums.trx250r.org/vbulletin_imports/1637_6970_2017-04-18_9580.jpg)

Title: New Member
Post by: croat1 on January 01, 2016, 05:01:22 PM

Welcome to the site Daniel!!!
 
Joe

Title: New Member
Post by: atv fan 28 on January 01, 2016, 06:09:30 PM

Welcome aboard Sir!

Title: New Member
Post by: Tbone07 on January 01, 2016, 06:36:47 PM

Welcome!

Title: New Member
Post by: red88r on January 01, 2016, 07:27:51 PM

Welcome and nice ride!!

Title: New Member
Post by: huntertools on January 01, 2016, 07:48:48 PM

Welcome, nice quad.

Title: New Member
Post by: jfwyatt1 on January 01, 2016, 09:44:44 PM

welcome !!!

Title: New Member
Post by: Skeans1 on January 01, 2016, 11:03:47 PM

Glad to see you made it over there's tons of info over here lots of the bigger motors are over here and no advertisements from a "builder".

Title: New Member
Post by: thesmith87250r on January 01, 2016, 11:11:50 PM

welcome to the site . rich

Title: New Member
Post by: hickwheeler on January 02, 2016, 12:08:34 AM

Welcome, I'm sure you will enjoy yourself here

Title: New Member
Post by: mandom250r on January 02, 2016, 01:52:24 PM

Welcome to the site, im mando from el paso. Where do you ride?

Title: New Member
Post by: TRXDAN on January 02, 2016, 02:19:57 PM

Thanks gor the welcome everyone.

Hey mando here in Albuquerque we haveca few places. There's 9 mile hill. We drag there and there a quite of few alcohol banshee that run..also we have some nice set of dunes also, theres quite a few other areas.What about in el paso any good dunes?

Title: New Member
Post by: mandom250r on January 02, 2016, 02:41:46 PM

We have 3 dune places but theyre small. Only 1 of them is where everyone goes and rides. We have 2 dirt drag strips also but dont have that many fast bikes. Would love to ride some different dunes

Title: New Member
Post by: Robsessed86 on January 02, 2016, 10:22:46 PM

Welcome to very good site. And that's a very sweet R.

Title: New Member
Post by: havinnoj on January 03, 2016, 10:17:53 AM

Welcome to the site!  Looks a lot like my first R - red Maier shark nose plastic looked killer!