TRX250R.ORG
Workshop => Engine and Bottom End => Topic started by: sam mc 2000 on August 03, 2013, 07:23:47 PM
-
guys i have some dings in my cases in the center where the crank is sealed from the tranny area in the center case is it beter to use treebond or honda bond to fill the ding so it dose not leak when i put cases back together
-
Either or I would say. I use three bond 1211 myself.
-
Use a straight edge to make sure its only slight low spots and no high spots. File any high spots and it should be ok. Not ideal, but ok.
-
ya I know it is not ideal the ding dose not go all the way across the flat area betwen the crank and trany but it goes about 3/4 across and it is on the tranny side of the flat hope sanding it down and honda bond with new gasket will stop it from leaking.
-
Just so we all are on the same page, Three Bond makes HondaBond. Chances are, the only actual difference is the color. Japanese companies like to put their name on products even if they don't make them, but they sell them. They consider it "total brand management".