TRX250R.ORG
Workshop => Suspension and Chassis => Topic started by: Wolvman99 on July 04, 2013, 04:06:21 PM
-
Did or does anyone make plus 2 long travel gull wing A arms that look like the plus 3 arms ? Like the look just don't want the extra width
-
Alba makes +2 arms for the 400ex that should work. I don't know anything about them, just what I read when I was shopping.
-
Gibson, and herman arms are the only two for 250r's i know of
-
Can you still get Gibson? They're some of the coolest looking arms.
-
kind of i can get parts for my +3's but if you dont know how/where it would be hard to do.
-
what about roll design? You can usually pick up a nice set pretty reasonable especially if they are 400ex.
-
Ok thanks do the 400 ex arms fit and handle good with the RITE size spacers ?
-
I have 400ex roll on mine and they work very well. I found that lsr bushings would press right into the roll a-arms and be the correct width so no spacers were needed. I also hated using heim joints on the top a-arms. So I replaced those with the std ball joint. 250r roll were harder to come by and they were more expensive used.
-
Gibson only came in a +3 for the gullwing I believe. Try calling east coast atv... Dave Gibson (who made the gibson arms) runs the show there. Maybe he can help you out a little more if you want to go that route
-
Actually gibson made a +1 gullwing setup for xc it looks like. I stumbled across this when I was shopping for gibsons for my hybrid. If you're interested I can get you the contact information of the seller who has them. They are for a 400ex but will work fine with spacers.