TRX250R.ORG

Workshop => Engine and Bottom End => Topic started by: The norm on July 20, 2019, 10:17:49 PM

Title: Ignition wire grommet
Post by: The norm on July 20, 2019, 10:17:49 PM

Hey fellas, I just picked up my 391 from hybrid engineering and I had Pete install a pvl ignition. The wires for the pvl don't have a grommet and I obviously do not want to run without one. So help me out here. What is the hot setup for sealing the hole in the case? Thanks Loren

(http://thumbs2.imagebam.com/5b/6e/81/6b23881280405354.jpg) (http://www.imagebam.com/image/6b23881280405354)

Title: Re: Ignition wire grommet
Post by: hickwheeler on July 21, 2019, 01:06:45 AM

I would think a normal grommet with some good old silicone would work

Title: Re: Ignition wire grommet
Post by: F-Red on July 21, 2019, 04:14:04 AM

A .50 grommet not included? What the what? As Gene said. McMaster-Carr should have what you need. 

Title: Re: Ignition wire grommet
Post by: croat1 on July 21, 2019, 10:57:36 AM

Quote from: hickwheeler on July 21, 2019, 01:06:45 AM

I would think a normal grommet with some good old silicone would work

As Gene stated...do you have any junk stators?  Call and see if Ricky Stator (or the other aftermarket electrical places) will sell a grommet. 

Joe

Title: Re: Ignition wire grommet
Post by: The norm on July 21, 2019, 01:30:54 PM

I have a junk stator just not sure if I can cut it off without destroying it. I will give it a shot because I can't wait to see what this engine will do!