TRX250R.ORG

Workshop => Engine and Bottom End => Topic started by: havinnoj on May 16, 2020, 02:53:34 AM

Title: Radiator Hose Clamps - What Width OEM?
Post by: havinnoj on May 16, 2020, 02:53:34 AM

It dawned on me today I’m not sure I even remember what the width of oem radiator hose clamps is - I’ve used 9/16” wide and 1/2” wide over the years but anyone know what came factory?  Have been using Tridon 13/27 10’s in stainless for years with good luck. 

Title: Re: Radiator Hose Clamps - What Width OEM?
Post by: Hawaiiysr on May 16, 2020, 01:54:34 PM

wasnt there a discussion about clamps? i remember Jerry jumping in on it also

Title: Re: Radiator Hose Clamps - What Width OEM?
Post by: Langbolt on May 27, 2020, 08:57:39 AM

If you want some nice non marring clamps in Stainless.....these are what I use :) 9mm

https://www.belmetric.com/stainless-norma-torro-9-12-c-15_145_1045/cr1320ss-norma-stainless-hose-clamp-9mm-wide-p-5703.html

Title: Re: Radiator Hose Clamps - What Width OEM?
Post by: havinnoj on May 28, 2020, 06:07:34 PM

Quote from: Langbolt on May 27, 2020, 08:57:39 AM

If you want some nice non marring clamps in Stainless.....these are what I use :) 9mm

https://www.belmetric.com/stainless-norma-torro-9-12-c-15_145_1045/cr1320ss-norma-stainless-hose-clamp-9mm-wide-p-5703.html

Yep Norma Torro clamps are great too.