TRX250R.ORG
Workshop => The Mad Scientist => Topic started by: croat1 on March 02, 2022, 07:51:36 AM
-
Dave Moore is working on some front hubs.
-
Pic…..
-
Mounted up
-
Do you know if the dimensions are based on the 86-87 hubs or the 88-89's? I see there 3 bolt like the 88-89 but are styled like the 86-87..... Reason I ask is the 88-89 hubs have a 3/8" offset compared to 86-87 hubs so if you run 88-89 hubs/spindles on an 86-87 yor get an extra 3/4" width. I have some LSR micro-lites on my 86 which take the 4 bolt rotor but they have the 3/8" wider offset like the 88-89 oem hubs.
-
Do you know if the dimensions are based on the 86-87 hubs or the 88-89's? I see there 3 bolt like the 88-89 but are styled like the 86-87..... Reason I ask is the 88-89 hubs have a 3/8" offset compared to 86-87 hubs so if you run 88-89 hubs/spindles on an 86-87 yor get an extra 3/4" width. I have some LSR micro-lites on my 86 which take the 4 bolt rotor but they have the 3/8" wider offset like the 88-89 oem hubs.
Hmmm. Good question kevin about what offset these are. I’ll inquire and report back.
Side note: Come to find out LSR had 2 offsets available for 86/87 hubs. What I don’t know if they were available at the same time.
Joe
-
Hopefully they will do a part revision and offer them with center caps.
Joe
-
Soon to be discontinued
-
I'm not a fan of how the maching leaves raw aluminum to oxidize and turn gray. Same with any otherwise anodized part...
-
Another question, the 400ex front hubs are still available in red 44615-HN6-000. Are these mechanically/dimensionally the same as the 250R hub?
this post seems to indicate that the rotor bolts and width between bearings may be different. https://www.trx250r.net/threads/hubs-for-400-ex-spindles.10119/