TRX250R.ORG

Workshop => The Mad Scientist => Topic started by: croat1 on August 02, 2023, 12:21:03 PM

Title: Rear master hose fitting (KMW Engineering)
Post by: croat1 on August 02, 2023, 12:21:03 PM

Another option.  Rear master cylinder hose connector.

Title: Re: Rear master hose fitting (KMW Engineering)
Post by: 2ndmoto on August 02, 2023, 04:58:00 PM

That looks good. I really like the raduis edges. Very clean

Title: Re: Rear master hose fitting (KMW Engineering)
Post by: The norm on August 06, 2023, 01:38:46 AM

I’ve seen these parts personally this weekend at the Winchester trx250r takeover. Ian (owner of kmw) drove up from Arizona. He has a great product!

Title: Re: Rear master hose fitting (KMW Engineering)
Post by: havinnoj on August 07, 2023, 02:57:55 PM

Quote from: The norm on August 06, 2023, 01:38:46 AM

I’ve seen these parts personally this weekend at the Winchester trx250r takeover. Ian (owner of kmw) drove up from Arizona. He has a great product!

X2 these are really nice pieces!

Title: Re: Rear master hose fitting (KMW Engineering)
Post by: All250R on August 08, 2023, 06:11:33 PM

I haven't found a great way to restore that plastic piece to a new look, so this seems like a good option.
honda oring info (probably made of epdm (not nitrile, etc)):
91212-422-006  (14.8X2.4)
https://rubber-group.com/wp-content/uploads/2018/01/Chemical-Compatibility.pdf