TRX250R.ORG

Workshop => The Mad Scientist => Topic started by: croat1 on October 25, 2024, 07:29:04 PM

Title: GP engineering clutch
Post by: croat1 on October 25, 2024, 07:29:04 PM

From Kevin Gigot.  6 spring clutch center hub and pressure plate.

Title: Re: GP engineering clutch
Post by: croat1 on October 29, 2024, 01:29:23 PM

I wonder if they are working on clutch basket cushions?  I’ll ask.  If not I might have a source here in NE Ohio to get them made.

Joe

Title: Re: GP engineering clutch
Post by: croat1 on October 29, 2024, 02:17:49 PM

I asked about the clutch basket cushions.  The response was that they are not aware of anyone working on them getting made.

Joe

Title: Re: GP engineering clutch
Post by: Hawaiiysr on October 29, 2024, 02:25:56 PM

I watched Dave's video. GSXR fibers and plates. I dig it. So is it using stock cusions?

Title: Re: GP engineering clutch
Post by: croat1 on May 03, 2025, 10:27:02 AM

Anyone here running this setup?

Joe

Title: Re: GP engineering clutch
Post by: Michael88R on May 03, 2025, 01:38:15 PM

Looks like a good set up according to Dave’s video

Title: Re: GP engineering clutch
Post by: croat1 on May 10, 2025, 07:24:52 PM

I wonder how the pins (more the pressure plate) are going to hold up not being “fixed” in position. 

Joe