TRX250R.ORG
Workshop => Engine and Bottom End => Topic started by: 4WHLr on April 10, 2025, 04:05:56 PM
-
I have a set of cases that have signs of what i believe is casting marks / issues. Of course its the left side.
I wanted to contact dave moore , but don't do facebook and I know everybody is pretty busy right now anyways, so i figured I'd ask some opinions here.
I've watched cases on ebay sell for good money with similar flaws.
These are replacement cases, which seems to be where i find this. I also see other new, unused replacement NOS cases with signs of this as well.
I also included a pic of a NOS case that isn't mine that shows it too.
Thanks for your thoughts and opinions.
Now i hope the pictures come out .(http://)
-
Here they are.
-
Hey Bill, I say you’re good. Casting flaws. Every time I’ve seen this brought up it’s a “no issues” “your good”.
-
Sand the area with a 150 to 200 grit cartridge roll until you can't see the blemish/crack. Put the case into the oven and heat the case up to about 200 deg. F. If there is a crack, oil in the crack will expand and the crack will become visible.
-
Thanks Joe. I think I showed these to you, and you thought maybe cracked at the time. None of that goes into the bearing ‘bore’ , and all the left side “off the shelf” NOS cases I see, that haven’t been ran yet, show signs of this.
That’s the only imperfection on the set, and just wanted to be sure, and honest about them when I go to sell them.
Thanks !!