TRX250R.ORG

Workshop => Body and Controls => Topic started by: robjust on September 21, 2026, 06:15:36 AM

Title: Rear frame protector / guard under rear of the seat/fenders
Post by: robjust on September 21, 2026, 06:15:36 AM

Does anyone remember who was making the rectangular frame protector that went over the rear seat cushions for the seat/fender alignment pins? It was possibly 3d printed with TRX on it, it had two holes to allow the rear seat/fender cushions to go through it and bolted down with a single countersunk bolt. I thought possibly a person, or company SG, but I have gone thought 7 years of notes and cannot find anything.

Title: Re: Rear frame protector / guard under rear of the seat/fenders
Post by: All250R on September 21, 2026, 03:31:36 PM

I'm not the right guy to tell you, but do you have a pic?
Packing tape helps protect the frame paint from the seat bushings. A nicer choice is xpel, but probably not what you're asking about.

Title: Re: Rear frame protector / guard under rear of the seat/fenders
Post by: croat1 on September 21, 2026, 07:15:07 PM

Maybe this?

Title: Re: Rear frame protector / guard under rear of the seat/fenders
Post by: robjust on September 24, 2026, 04:47:09 AM

Joe, that is exactly what it !! Thank you so much for this, and for everything you do to support the community. You are amazing. (and know you will be missed at LSOK this year)

Gratefully,

Rob