TRX250r.org

See likes

See likes given/taken


Posts you liked

Pages: [1]
Post info No. of Likes
Re: 1988 trx250r rear motor mount issue(please advise) I wouldn't call factory engineering a reason to keep something the same necessarily lol, but I've only read of head gasket problems. Never seen one personally.

I can say that I do not use one and it does not cause any problems. 

To the OP, you can google this question and read about it for days if you want.

December 19, 2018, 09:19:56 AM
1
Re: 2019 250R Calendar Yes we do fred! My 12 year old boys will love it
January 05, 2019, 01:03:47 PM
1
Re: Swingarm Skid plate OK, I measured it. My swing arm is a +2". My measurements are close, not how I would normally do it but, here ya go;
from the swing arm pivot centerline its ~6" to the first skid mount, the mounts are 5"3/16" apart. Then it is 14"3/8" from the first mount, to the mount closest to the axle carrier,             Those mounts are 3"5/16" apart. All are tapped to 8mm x 1.25mm Of course that is "IF" Lonestar got them right. and I don't have a lot of faith in them.
Swing arm measures 21".5" center to center.
desertR

April 07, 2020, 10:17:51 PM
1