TRX250r.org

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hickwheeler

Pages: [1] 2 3 ... 81
1
I have not had one go bad yet. They usually get messed up taking the pipe off. Because they get soft

2
Duner / Re: 2019 Winchester bay 250r meet!
« on: May 22, 2019, 01:57:17 PM »
ESR has moved to Oregon. He is a little south of coos bay

4
Engine and Bottom End / Re: ESR communication
« on: May 21, 2019, 01:21:18 PM »

5
Engine and Bottom End / Re: ESR communication
« on: May 21, 2019, 01:17:26 PM »

6
Engine and Bottom End / Re: ESR communication
« on: May 21, 2019, 01:15:35 PM »

8
Duner / Re: 2019 Winchester bay 250r meet!
« on: May 19, 2019, 02:31:54 AM »
I'll be there

9
I buy the o rings for the KTM 300 and 250. They are thicker. I usually have to grease them to slip the pipe on. A little patience helps too. Seems to seal good with no rvt. You kinda have to stretch them over the flange

10
Wanted / Re: 01/00 Cr cdi try?
« on: May 10, 2019, 11:43:24 AM »
Have you done a resistance tests on the stator?

11
Wanted / Re: 01/00 Cr cdi try?
« on: May 10, 2019, 03:47:20 AM »
The extra ground you ran from the coil. Did you go to the motor with it

12
Wanted / Re: 01/00 Cr cdi try?
« on: May 09, 2019, 10:55:52 PM »
You will be better off in the long run to fix it your self. It's a learning experience

13
Wanted / Re: 01/00 Cr cdi try?
« on: May 09, 2019, 10:54:43 PM »
I still think it is a ground issue. Since it doesn't do it all the time

14
Wanted / Re: 01/00 Cr cdi try?
« on: May 09, 2019, 05:55:38 PM »
You might have better luck shipping your CDI to someone to test it.

15
For Sale - Misc Stuff / Re: TRX70
« on: May 04, 2019, 03:28:14 AM »
I hope you got the amount you wanted Joe

Pages: [1] 2 3 ... 81