TRX250r.org

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hickwheeler

Pages: [1] 2 3 ... 79
1
Projects / Re: 2Nubs's boondock build
« on: Today at 10:38:46 AM »
Cool pics Myles

2
Lounge / Re: I did it again
« on: April 20, 2019, 11:26:44 AM »
Is yours a 350x frame

3
Lounge / Re: I did it again
« on: April 20, 2019, 04:53:47 AM »
Doing a ATC has definitely crossed my mind. Just haven't seen a good candidate yet

6
Carburetor, Intake, and Exhaust / Re: adjustable air screw
« on: April 19, 2019, 07:40:20 PM »
Look at JD jetting. They should have what you are looking for.

7
Projects / Re: My cry once going big puma build
« on: April 19, 2019, 02:07:05 PM »
Picking pipe up monday

8
Lounge / Re: I did it again
« on: April 19, 2019, 02:11:17 AM »
Mine's almost done ;D the 350X motor is tall for the "R" frame, and it needs to be drop'ed at the lower frame rails. I added a BIG oil cooler and stainless oil lines, and have a Trail Tech Vector and cylinder head sensor, and A fin mount sensors for the cooler to monitor temps. I have a 400EX pipe and carb to run with a custom adapter to mount a K&N filter. I have a Supertrapp muffler mocked up, just need to add the 10" of pipe to finish it off. I need to weld a couple brackets on the frame and then send it out for powder, everything else is done.
desertR
I would really like to see pics of this please

9
Lounge / Re: I did it again
« on: April 19, 2019, 02:09:53 AM »
That's cool Gene! Is the one on the right the same one that I got from you?
No Kevin these are 2 new ones I just picked them up

10
Lounge / Re: I did it again
« on: April 18, 2019, 02:45:21 PM »
I doubt I'll go that big. But since I have frames now I'm willing to cut on. I will be doing a 350rx build

11
Lounge / Re: I did it again
« on: April 18, 2019, 02:26:32 PM »
350x take outs

12
Lounge / I did it again
« on: April 18, 2019, 12:40:28 PM »
 

13
Projects / Re: My cry once going big puma build
« on: April 17, 2019, 10:49:06 PM »
I can't wait

14
Projects / Re: My cry once going big puma build
« on: April 17, 2019, 04:59:52 PM »
I got the call from led. My pipe is done. So just got to go pick it up. Will drop some more off to Pete also that I forgot

15
Duner / Re: 2019 Winchester bay 250r meet!
« on: April 17, 2019, 02:45:18 PM »
Sounds like you need to talk to Tony about that stocker Joe

Pages: [1] 2 3 ... 79