There was some interest in how the LED intake fit the Roll Design Lobo frame. I thought I would share some pictures.
Plenty of clearance around the plastics (old Fullbore), frame and head-to-pump coolant hose. I did end up running a different coolant hose that runs from the pump to the radiator. There are some frame supports that push the stock hose too close to the pipe. It is a Gates hose Part# 19707. Had to do a little trimming, but it fit well.
There might be a better hose out there, but this was available at the auto parts store...and, come hell or high water, I was going riding the next day. The crude exhaust bracket was my own design, as Roll failed to design a frame with an exhaust mount. I had to run this bracket back to the gas tank mount. I'll have LED fab me up something soon.
Here is the Intake. LED does make a few different ones. This one is specific to the Lobo chassis. It is tight, but there is clearance from the shock being fully extended to bottomed out. I am going to see about getting an air box made.
If you would like to see any specifics, let me know.
Best Regards
-Jason
