1
Engine and Bottom End / Kicker Starter Poor Engagement: Possible compression spring fix
« on: April 10, 2015, 12:40:50 AM »
I appreciate your updates on your findings.My kicker slips a bit and need to look into taking care of it.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
JohnnyFive,I was running the 88 89 dogbone which is 6in
I just went out and measured my dogbones and I too was running the 6 3/4 dogbone before I switched to the LRD dogbone. If your linkage was hitting the swingarm then you obviously had the wrong dogbone on there. What year is your frame, because the LRD dogbones were made for the 88/89 bikes. When you say that you were a half inch longer from the linkage mount to the dogbone mount then your bros bike. Do you mean the dogbone mount on your swingarm? Could you guys possibly have different swingarms or you may have just been running the wrong dogbone. If the LRD Dogbone fixed all your problems then I'd just run that dogbone!!!
Thanks Higgy
What up Johnny Five,
I'm running the elusive LRD Dogbone if I remember there's a little difference between the 2 dogbones one is just a little longer then the other, but I figured if its an LRD DogBone it should probably be ran on this LRD Bike!! Coincidentally I just might know where to find I just might know where to get you one brand new LRD Dogbone if ur interested?
Thanks Higgy