TRX250r.org

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - huntertools

Pages: [1]
1
Lounge / Loretta Lynn's
« on: August 08, 2016, 10:05:57 AM »
Anybody going to Loretta Lynn's this weekend? I'm sure it's going to be good as always. Let me know I would like to meet if your coming.
Allen

2
Engine and Bottom End / New ESR motor running great
« on: June 17, 2016, 08:00:42 PM »
Just got my new motor in and live it.
New 310 ESR cylinder ported by Neil (thanks Neil)
New ESR cases, clutch cover, stator cover
New Hot Rod crank and seals and bearings.
Started out jetting fat with all new electrical except CDI that was my spare Ricks cdi
. Motor started up second kick and sounded good. Did about three heat cycles then rode around the yard maybe quarter throttle for five minutes. Was running a little hot so checked everything and found no problems. Made several more runs like this and was still too hot for my liking 200F. Didn't feel like it had as much bottom end power but I blamed this on the jetting. Got a OEM cdi and it made a huge difference. Temp dropped to 180 and pulls hard with plenty of bottom end power. Almost like a four stroke. Sure I will be going up on my gearing soon.
Thanks again Neil for an awesome port job. Better than I expected.

3
Pics and Vids / Almost done!!!
« on: October 22, 2015, 12:22:04 PM »
Here's where I'm at now.








4
Wanted / Roll Design long travel a arms
« on: September 25, 2015, 11:25:30 PM »
(FOUND)Looking for a nice set of Roll Design gull wing a arms. Must be tight and in good shape.
Thanks

5
Lounge / Loretta Lynn's
« on: August 03, 2015, 09:46:05 PM »
Anybody going to Loretta Lynn's this weekend? Lots of good racing!!

6
Wanted / Chrome clutch cable holder/stay
« on: May 25, 2015, 02:11:20 PM »
Looking for a chrome clutch cable holder or one not chromed that I can send off.
Thanks Allen

7
QOTM - Sponsored by Eddie Sanders Racing / Eddie is the man!
« on: May 19, 2015, 04:27:07 PM »
Ordered a new set of cases and applied my $100 Quad of the Month credit on the bearing & seal option. Cases delivered in four days and also Eddie gave me free OEM clutch, center case, and stator gaskets. Thank you Eddie!!!!

Pages: [1]