See likes given/taken
Post info | No. of Likes |
---|---|
CP Industries RETAIL prices for Sphynx, Puma, Sabertooth
reposting this because the issues with the attachments April 20, 2014, 10:26:50 PM |
1 |
Clutch Mod with Pics (Neil aka C-Leigh Racing Mod) - Pic Heavy
Quote from: hickwheeler;27359 since I'm New to the r what does this accomplish By adding washers to the springs you are compressing them more and increasing the spring pressure therefore increasing the clamping power of the clutch. By adding a thicker steel clutch plate from a 400ex you also compress the spring more and increasing the spring pressure. The reason the thicker plate compresses the springs more is the clutch plates and fibers assembly is now taller on the inner hub so the pressure plate is now pushed out farther but the springs are held in by the inner hub so with the pressure plate farther out the springs are compressed even more. Now you may need to add a small washer like shim behind the pressure plate to get the clutch arm located correctly because of the extra thickness, in the case of PNWrider the clutch stack is .64mm or .025" taller, this may not seem like much but that is allot in clutch arm movement. IMO a .020-.025" thick washer should be added to the push rod bearing/pressure plate Now IMO you can do a clutch mod a couple other ways also 1 - add another 250r steel disc and double it up with another steel disc in the clutch assembly, normally this is installed toward the center area of the clutch assembly this will add 1.30 mm to the clutch plate and fiber stack so you will want to add about .050" shim washer at push rod bearing/pressure plate, the 250r springs can be used with mod but they get very stiff and normally just drag guy will do this The bad thing IMO about the extra plate is the extra rotational mass added which is normally not a good thing to add to the engine. 2 - instead of the thicker 400ex plate in Neil's mod try finding a washer that is .025 thicker than the oil drain washer being used in Neil's kit. this will accomplish the same thing as the thicker 400ex plate without the extra rotating mass. Maybe Tony can cut us washers if that is possible to accomplish this March 02, 2014, 08:46:10 AM |
1 |
New 1985 ATC cases
Brand new 1985 ATC cases, stator cover, water pump, trans and crank bearings along with all case bolts 900 cash or PayPal gifted September 10, 2018, 11:03:35 PM |
1 |
Brand new 1986 ATC motor complete
This is a brand new never ran motor that Honda removed from a brand new 1986 ATC back in 1987 When they removed them they just cut the hoses, cables and and stator wires So they will need replaced and the stator wire repaired This my last one but I will say that we ran a couple without ever taking them apart and had no gasket issues But I can’t guarantee that would be your same experience 2200.00 plus the ride my guess the shipping will cost 50-75.00. Or come by and pick it up Cash or PayPal gifted Thanks Dave September 10, 2018, 11:08:22 PM |
1 |
Re: Brand new 2000 stator/flywheel 2001 CDI 700.00 shipped
Sold. Thanks!
September 14, 2018, 03:53:02 PM |
1 |