Messages

1

For Sale - Parts / Re: TRX 250R - parts - Duncan Racing, LRD '86-'89

« on: July 11, 2022, 01:47:54 PM »

PM Sent

2

Carburetor, Intake, and Exhaust / Snorkel for big bores

« on: August 26, 2016, 09:22:14 AM »

I run the cfm airbox with some outerwear material fastened down as a lid. So far so good dealing with splashes and what not.... Also using silicon adapter/hose to go from airbox to BB motor. If you want a pic i can get one. That Robl one wasn't ready when i was building my r

3

Carburetor, Intake, and Exhaust / Plug chop on 350 Pro-X

« on: August 26, 2016, 09:16:15 AM »

From the pic it looks a little rich to me.... should only be seeing about a 2mm ring around the bottom and more cardboard brown... good start tho!

4

For Sale - Parts / New Esr Quick change and New 89 style Water pump shaft

« on: March 10, 2016, 05:17:31 PM »

PM Sent

5

For Sale - Parts / New Esr Quick change and New 89 style Water pump shaft

« on: March 09, 2016, 10:56:09 PM »

Still available?

6

For Sale - Parts / Huge quality engine lot -polished, hinson, oem crank, cr 250 ign, esr carb, pwr

« on: January 21, 2016, 10:35:45 AM »

PM Sent

7

Wanted / Big Bore Cases

« on: January 21, 2016, 08:36:29 AM »

Looking to purchase some cases that are machined for a big bore kit. Please let me know what you have and what you are asking.

Thank-you

8

For Sale - Parts / parts

« on: October 19, 2015, 08:25:23 AM »

Do you still have the airbox eliminator?

9

For Sale - Parts / Nacs seat

« on: July 22, 2015, 11:58:06 AM »

PM Sent

10

Engine and Bottom End / Race gas or no?

« on: May 01, 2015, 10:43:15 AM »

Do a UCCR test. There not too difficult and that will give enough information.

11

Carburetor, Intake, and Exhaust / Thinking about getting a new carb.

« on: April 13, 2015, 11:44:47 AM »

Looking at getting this carb as well! I have a similar setup. .020" over with a fmf "rev" pipe and vforce 2 reeds. Should we be changing our pipes if we go with the A/S or will the FMF's be fine until more motor work is done?

12

Wanted / ISO 38mm or 39mm Keihin Carb

« on: April 10, 2015, 01:52:14 PM »

Anybody have one for sale? PWK or Airstryker? Let me know!

13

For Sale - Parts / Two Keihin carbs for sale. 38mm airstryker & 40.5mm PWK

« on: April 10, 2015, 11:03:17 AM »

PM sent.

14

For Sale - Parts / Two Keihin carbs for sale. 38mm airstryker & 40.5mm PWK

« on: April 10, 2015, 11:01:14 AM »

Anything wrong with the Airstryker? Does it come with jets & needle?

15

Lounge / Cool old school ported cylinders

« on: April 08, 2015, 02:11:39 PM »

My PT Hyperdyne.... would really like to get it setup and see how it runs! Don't know if it's worth spending money on though...