TRX250r.org

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MotoX_Racer07

Pages: [1]
2
I’m fine paying a fair price for parts & shipping honestly. PayPal works for me, I appreciate it.

3
No, I just do these for my personal bikes and I’ve done a few of my buddies in the past. Ones I’ve done in previous years back were Cr250 Shafts I cut off machined and tig welded to bad trx250r shafts. The new ones I’m making are comeplete new shafts and splines. I just tig weld the actuator on the end. I made a fixture off a good shaft for proper alignment of splines and the actuator. I’m just trying to make obsolete parts go further and refuse to pay the eBay prices for worn splines.

4
I’ll buy your old junk, unusable bent, stripped splined, welded or cut off shift shafts. I machined a few new splined shafts for few motors I’m piecing together from all the parts l’ve been accumulating over the years. Just need the actuator on the ends to weld to the shaft. Thanks

Pages: [1]