Messages

1

Engine and Bottom End / F.A.S.T. Racing?

« on: April 16, 2015, 11:39:13 PM »

Just curious, how much does a good port job cost?

2

Engine and Bottom End / F.A.S.T. Racing?

« on: April 16, 2015, 02:47:27 PM »

why are you so dead set on using someone just because they are near you? that is what telephones and shipping services are for. there are builders completely dedicated to building our specific bikes, that have done the R&D to know the little nuances these specific cylinders need. shops like these that say they will port anything have not done this.

$150 for a port job is a red flag. you will get what you pay for.

I'm not dead set on using someone close. I was simply asking if anybody had used them. I have seen some of the banshee they've built at Little Sahara and they were fast. I'm sure they would do a decent job and they don't charge much more than that to do the banshees.

3

Engine and Bottom End / F.A.S.T. Racing?

« on: April 14, 2015, 11:40:33 PM »

Has anybody used them for porting? They are located in Holton,KS. It's not too far from me so I was thinking about taking my stock cylinder to them to port when I rebuild it.