Messages

1

Suspension and Chassis / Who sells Roll design bushing kits

« on: June 23, 2016, 09:53:51 PM »

Who sells the a arm bushing kits for the roll design + 2 a arms.

2

Engine and Bottom End / Case assembly gasket, Assembly of cases

« on: February 01, 2015, 01:08:09 PM »

I am assembling the cases and I am using an oem gasket. Should I put Honda bond on it on 1 side or both sides or an anerobic sealant or nothing. It is a 350 BB cylinder with bored cases. Is it best to heat the main bearing up with a heat gun then use all thread thru the motor mount holes to pull together? Looking for the right way the 1st time. Thanks