Messages

1

Engine and Bottom End / Race gas or no?

« on: April 22, 2015, 01:56:00 AM »

yea way to endepth I'll just run race gas. Not going to tear my cylinder back off to take pictures for just switching to a different head.

2

Engine and Bottom End / Race gas or no?

« on: April 21, 2015, 11:41:21 PM »

Figured some engine guru could chime in with that info and say pump 50/50 or 110

3

Engine and Bottom End / Race gas or no?

« on: April 21, 2015, 09:57:18 PM »

68.5mm short rod and 20cc cool head, Cylinder is ported by sand trix. Does it need race gas?

4

Engine and Bottom End / New Esr Pv cylinders

« on: February 09, 2014, 11:31:55 AM »

Nm I see what's going on here. Thanks guys

5

Engine and Bottom End / New Esr Pv cylinders

« on: February 09, 2014, 03:42:41 AM »

http://www.eddie-sanders-racing.com/product_p/310-cyl-npv.htm

You can tell they are completely different from the ones that where out this time last year and prior. The Pv use to stick up like the one on the main page. Cylinder casting also looks different too.

6

Engine and Bottom End / New Esr Pv cylinders

« on: February 08, 2014, 02:38:55 AM »

How do they compare to there old cylinder and Pv setup? I sold my r this time last year and these weren't out yet.

7

Engine and Bottom End / New Esr Pv cylinders

« on: February 08, 2014, 02:38:01 AM »

Is anyone running them? This new style wasn't out when I sold my r this time last year. How do they compare to there old cylinder and Pv setup?

8

Engine and Bottom End / New Esr Pv cylinders

« on: February 08, 2014, 02:33:36 AM »

How long have these new ones been out? I sold my r this time last year and it was a different cylinder back then. Is anyone running these yet? Any dyno runs? How do they run with there clean up trx9 and not there full port job

9

Engine and Bottom End / New Esr Pv cylinders

« on: February 08, 2014, 12:21:58 AM »

What's the word on these? Just bought my old r back for $500 and she needs a new cylinder.