TRX250r.org

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - j@y

Pages: [1] 2 3
1
Pumashine 250R Products / Pumashine Exhaust Hangers
« on: October 16, 2015, 08:23:49 PM »
hey do you have these back in stock again? last time we talked you were out of the black delrin.

2
some with engine size might draw some attention. trx310r 330r 350r etc

3
LED Performance / LED built ATC 330R
« on: October 16, 2015, 07:58:00 PM »
looking good! who did your clamps and such for the inverted forks?

4
ATC250R / dave moore chromoly atc frame
« on: October 16, 2015, 07:25:27 PM »
someone just got one of these last week I believe. They are available in the drag format but not the mx version yet.

5
For Sale - eBay Auctions / Rad valves cheap
« on: September 14, 2015, 11:28:50 PM »
Just the reeds. Not the cage

6
Lounge / My Dyno Room Progress
« on: March 09, 2015, 09:42:10 AM »
Nice!!! with a capital N lol

7
Hybrid 250R / Kx500-r
« on: February 26, 2015, 12:01:45 PM »
subscribed!

8
Lounge / Everyone's profession
« on: February 12, 2015, 10:36:28 AM »
LTL driver for saia freight

9
bump ^

10
I have a low hr oem bottom end so no need for the cases esp since I'm running 265 topend

11
Also selling my (NEW) Blk anodized ESR cases that are set up for the 350 topend and a longrod crank. BEARINGS INCLUDED "YOU DO NOT NEED A SPACER PLATE" when using these cases $599 shipped STAND NOT INCLUDED

12
I've decided to run my ported 265 top end for now and I'm selling my ESR CLeigh ported 350.


ESR 350 NON PV topend XC ported and set up for 104+ octane race fuel. This top end is brand new(0 HRS) and came as the builders kit. I sent it off to Neil and he had his machinist bore out the cylinder with .0030 piston to bore clearance. All gaskets and seals INCLUDED but not pictured.


I'm wanting $950 shipped which is basically the cost of the kit, port job, and bore job minus all the shipping cost I paid. Plus you'll save yourself the downtime

13
Lounge / Why don't no one responded at ESR
« on: October 28, 2014, 11:34:26 AM »
I'm still undecided on mine. Anodizing makes them look dingy to me.

14
Pics and Vids / My sand dune video little Sahara Oklahoma
« on: October 22, 2014, 09:22:55 PM »
Lol! if those were squids the guy who made that comment obviously doesn't get out much. Nice video, by the way

15
Engine and Bottom End / Any OEM clutch baskets look like this?
« on: October 22, 2014, 08:55:58 PM »
Hopefully so! Thanks for all the replies. It's not that exact basket but it's the closest pic I could find online. And by the way, puma you need to add a cart feature on the site lol. I bought a ONLY a stand from you today because I had to check out after clicking purchase.

Pages: [1] 2 3