Messages

1

Carburetor, Intake, and Exhaust / air stryker or no air stryker

« on: April 02, 2014, 08:24:46 PM »

Rebuilding my bike the threads were destroyed and the lid no longer threads on. I am replacing it. 38pwk or 38pwk AS.  The bike will be a BB ESR 350-370 duner any suggestions?

2

Engine and Bottom End / clutch basket question

« on: April 02, 2014, 03:45:11 PM »

I guess I misunderstood. Thanks for the heads up.

3

Engine and Bottom End / clutch basket question

« on: April 02, 2014, 10:50:35 AM »

I do not see it being a issue as I am pulling the gear off the basket the bike has been running for 28 years lol.

4

Engine and Bottom End / clutch basket question

« on: April 01, 2014, 06:21:46 PM »

Thanks I just ordered a new Hinson Basket can I used the stock cushions bolts plate?

5

Engine and Bottom End / Carb and reed spacers

« on: March 31, 2014, 07:48:05 PM »

I have never ran reed spacers unless I actually needed space not for performance. I think you would be fine e without the spacer.

6

Engine and Bottom End / clutch basket question

« on: March 31, 2014, 07:46:40 PM »

It has not been to bad. The reason I pulled it apart to begin with is when hill racing I would try to grab a gear under full load and it would take a bit before it actually shifted.

7

Engine and Bottom End / clutch basket question

« on: March 31, 2014, 06:46:19 PM »

Bought a 250r last week it has been a couple years since my last one. I am going through things to make sure it is tight and correct but the clutch basket fingers have grooves in them should the basket be replaced or is there a certain point were it is OK?