Show Posts
1
Engine and Bottom End / Mugen ported cylinder ?
« on: April 21, 2014, 03:57:07 PM »
Hello Guys,
I'm new to this board, I'm from Belgium by the way...
I have a question about a cylinder, I have it for a couple of years and bought it in a partslot, I don't even know which one exactly, because I bought lots of stuff over the years from differtent people. Any way, I never took a close look at this particular cylinder, but while I was searching through my parts this weekend, I took this cylinder of the box and noticed an engraving in it, when I looked closer, I noticed it is the Mugen logo :confused:.
I never, ever have seen this before, I also searched the net, and cannot find any other cylinder like this. It's definitly a stock cylinder, but it has been ported. Does any one know if Mugen actually did portwork on stock cylinders ?
I have a couple of pictures, but I will take some of the inside next weekend:
I'm new to this board, I'm from Belgium by the way...
I have a question about a cylinder, I have it for a couple of years and bought it in a partslot, I don't even know which one exactly, because I bought lots of stuff over the years from differtent people. Any way, I never took a close look at this particular cylinder, but while I was searching through my parts this weekend, I took this cylinder of the box and noticed an engraving in it, when I looked closer, I noticed it is the Mugen logo :confused:.
I never, ever have seen this before, I also searched the net, and cannot find any other cylinder like this. It's definitly a stock cylinder, but it has been ported. Does any one know if Mugen actually did portwork on stock cylinders ?
I have a couple of pictures, but I will take some of the inside next weekend: