Messages

1

Engine and Bottom End / 01 cr ignition specs

« on: May 09, 2015, 11:22:14 PM »

Thanks for the info during diagnosis I found umberto fuel oil mix in air box boot check ed the reeds and sure enought broken reed replaced it and it's running the way a r should to bad Im the owner of 38as now

2

Engine and Bottom End / 01 cr ignition specs

« on: May 09, 2015, 11:30:30 AM »

I think I found my issue the one reed on vforce came loose and a dime size piece is missing out of the corner

3

Engine and Bottom End / 01 cr ignition specs

« on: May 08, 2015, 06:44:01 PM »

Anyone have test specs on a 01 cr ignition quad breaks up under a load change from 38 tmx to a 38as changed jetting on both and still has breaking up some times low end sometimes up top were ever it wants two

4

Carburetor, Intake, and Exhaust / tmx 38 flat slide

« on: May 04, 2015, 09:33:05 AM »

tmx from a cr250r

5

Lounge / dipping parts

« on: May 01, 2015, 08:29:48 PM »

when done corectly it will  hold up well this is the same process that you would get if you had oem camo plastics they are hydro dipped

6

Carburetor, Intake, and Exhaust / tmx 38 flat slide

« on: May 01, 2015, 06:58:09 PM »

im haveing some trouble jetting were is a good base to start with i have an 89 long rod on a esr330pv paul turner pipe tmx 38 cr ign k&n no lid on 105 32to1 mix ratio

7

Wanted / looking for a bb pipe

« on: August 17, 2014, 03:17:34 PM »

looking to buy a big bore pipe setup for my 86

8

Engine and Bottom End / crank gears

« on: July 20, 2014, 04:40:59 PM »

is there supposed to be some play between the drive gears on the crank and the counter balance gear

9

Engine and Bottom End / counter balance

« on: July 06, 2014, 08:37:09 PM »

any one know were I can get this rebuilt

10

Engine and Bottom End / head stay or no head stay

« on: June 30, 2014, 05:38:56 PM »

i run a esr 330pv in my 86 I just got done repairing motor mounts and frame from the motor destroying them was wondering if I should run a head stay or not I ride woods only