Recent Posts21
The Mad Scientist / Re: Rear caliper mount
« Last post by All250R on March 31, 2026, 08:12:28 PM »Joe,That is really close, especially if it floats center line with the rotor.
This pic shows how close the CRF Caliper mount is to the TRX Support.....it's off by 1/4"
So, either supply a NEW Steel Support....which I have made out of Stainless.
Or supply a NEW Caliper mount to adapt to the TRX support.
Is the leverage ratio the same as the stock caliper too (calculate piston face area)?
It's so close that HONDA should have made it the same size...
The Caliper Pistons are the same diameter, so I would say the lever ratio is the same....it works really good and it's a very clean look.
I haven't done much with R tech, or riding since we focused on our relocation to ID.
That caliper is still used for 2026 bikes. Have you done anything to make this a kit for people to buy? If the leverage ratio is the same, seems like a great solution, given how many stock pistons and calipers are corrosion damaged by now.
I still need to get my cylinder head prototype dome machined and tested - however, my lathe got damaged in the move. At least I have lots of ground to actively test now.