TRX250r.org
« previous next »
Pages: [1]   Go Down

Author Topic: alright long rod crank, long rod piston, ahort rod cylinder...HELP  (Read 1778 times)

Offline Tyler 54

alright long rod crank, long rod piston, ahort rod cylinder...HELP
« on: November 04, 2013, 06:53:31 PM »
I have the following to work with long rod crank, short rod cylinder and a long rod piston. Can this be made to work with a spacer plate???
Logged

Offline rsss396

alright long rod crank, long rod piston, ahort rod cylinder...HELP
« Reply #1 on: November 04, 2013, 07:00:22 PM »
dont need a spacer, the piston is matched to the crank that is all that matters
they move the pin 5mm higher on the 87+ pistons because the rod is 5mm longer, the cylinder deck height is the same on all years
Logged
Anyone looking for a great builder I highly recommend the following.
For CP products dealers I would recommend:
Arlan at LED(site sponsor), Pete Schemberger at Hybrid Engineering, Mat Shearer at Shearer Custom Pipes, Dennis Packard at Packard Racing, and Nate McCoy of McCoys Peformance.

Other great builders I also would recommend: Neil Prichard, Jerry Hall, Bubba Ramsey and James Dodge.

Offline Tyler 54

alright long rod crank, long rod piston, ahort rod cylinder...HELP
« Reply #2 on: November 04, 2013, 10:10:55 PM »
Sweet, so I'm good to go. Thanks man!!!
Logged
Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38