Author Topic: ROLL Swingarm 88/89 Std Linkage w/chain guide (Read 5561 times)

bnau267 · « **Reply #15 on:** June 02, 2014, 11:46:05 AM »

Quote from: Flyin_250r;35600

Ahhhhhhhhh shamrocks!

Someone said DWT will still make them as a special order for those willing to pay.

Flyin_250r · « **Reply #16 on:** June 02, 2014, 05:18:11 PM »

Quote from: bnau267;35609

Someone said DWT will still make them as a special order for those willing to pay.

Yeah far out of my price range. I have one mint set for the lobo, and another set that isn't the best ill probably powder black

Rockingkfarms · « **Reply #17 on:** June 02, 2014, 09:38:33 PM »

Bnau
It took a little time but both him and the swingarm were located. Good to see it go to someone that'll make use of it.

bnau267 · « **Reply #18 on:** June 02, 2014, 10:54:18 PM »

Quote from: Rockingkfarms;35652

Bnau
It took a little time but both him and the swingarm were located. Good to see it go to someone that'll make use of it.

I appreciate all your help. Me and my new swingarm got personal today! Let's just say it's best to keep your hand away from the slide stop end of the the bearing puller. Worst part is it happened while pulling the first bearing. Nice part is it took all of five minutes to pull the bearings.

CeaserTheThird · « **Reply #19 on:** June 04, 2014, 04:25:00 AM »

Ouch! Any pictures of the bearing puller??

bnau267 · « **Reply #20 on:** June 05, 2014, 07:35:10 AM »

Quote from: CeaserTheThird;35764

Ouch! Any pictures of the bearing puller??

Tusk - the one collet just barely fits. I'll post a pic of the tool/collet. Works like magic as long as they aren't completely rusted/bonded to the swinger. I use an air chisel for those.