Author Topic: 86' Cylinder (Read 2484 times)

Nickthompson · « **on:** April 15, 2014, 12:45:37 PM »

86' non ported cylinder. Has stock bore replacement sleeve in it. Cylinder has been sitting for about 4-5 years on the shelf so it has light rusting to the sleeve. The head also has been repaired where coolant inlet is. This cylinder ran perfect when motor was dissassembled due to cases being busted. 100$ shipped

Pumashine · « **Reply #1 on:** April 15, 2014, 12:50:31 PM »

Yes, it has been ported. But I can only tell you its not stock.

Nickthompson · « **Reply #2 on:** April 15, 2014, 01:46:55 PM »

How can you tell? I would like to know for future reference and I don't want to misinform anyone on a listing

Pumashine · « **Reply #3 on:** April 15, 2014, 05:01:56 PM »

All the aluminum to steel mating surfaces have been smoothed. Its called matching. The knife edge you see in middle of the bottom pic above is square on a stock cylinder.

Nickthompson · « **Reply #4 on:** April 15, 2014, 05:22:23 PM »

Thanks for clearing that up! So guys its had some work just not sure what/who did it.

Pumashine · « **Reply #5 on:** April 15, 2014, 06:04:42 PM »

Usually when someone re-sleeves a stock cylinder it most likely means it was a great working cylinder.

Nickthompson · « **Reply #6 on:** April 15, 2014, 08:04:17 PM »

The R it came off of was pretty snappy! Buddy put it together and ran it for about a month then chan snapped and destroyed left case. I got motor in a deal a fews back and this cylinder has sat on a shelf in my barn since then.

Nickthompson · « **Reply #7 on:** April 17, 2014, 02:32:20 PM »