TRX250r.org
« previous next »
Pages: [1]   Go Down

Author Topic: 44mm Lectron Meth to Gas  (Read 2620 times)

Offline Bio86

44mm Lectron Meth to Gas
« on: May 05, 2014, 08:36:10 AM »
Anyone know if it's possible to tame down a 44 lectron to run on a stock cylinder 293cc?  Right now it's setup for meth running a pump and dual lines to the power jet, regular clear bowl.  I have one laying around so figured I'd attempt before buying another carb.  Any suggestions are appreciated.
Logged
McCoy\'d

Offline rsss396

44mm Lectron Meth to Gas
« Reply #1 on: May 05, 2014, 08:51:22 AM »
yes just call dennis packard racing and he will sell you a gas needle and a float needle for gravity feed, the powerjet will just be run at a couple turns open normally. 7-2 is a typical gas needle and the float needle is a Mikuni piece
Logged
Anyone looking for a great builder I highly recommend the following.
For CP products dealers I would recommend:
Arlan at LED(site sponsor), Pete Schemberger at Hybrid Engineering, Mat Shearer at Shearer Custom Pipes, Dennis Packard at Packard Racing, and Nate McCoy of McCoys Peformance.

Other great builders I also would recommend: Neil Prichard, Jerry Hall, Bubba Ramsey and James Dodge.

Offline seanoktm

44mm Lectron Meth to Gas
« Reply #2 on: May 05, 2014, 09:43:21 AM »
Call Dennis at packard like rsss396 said. I run 4-2xl needles in 36/38mm lectrons on my girl friends gas 4mm stock cylinder banshee.
Logged
JDI Racing

Offline Bio86

44mm Lectron Meth to Gas
« Reply #3 on: May 05, 2014, 03:39:23 PM »
Awesome, thanks guys I'll give him a shout.
Logged
McCoy\'d
Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38